Welcome to your H&S and Regulations Exam. When you are ready, please press "start quiz".
1.
In a swimming pool or other basin, the metallic covering or sheath of a wiring system in zones 0,1 or 2 shall?
2.
What does the abbreviation PEI stand for?
3.
Which of the following is not classed as notifiable work under Part P of the building regulations?
4.
Which of the following falls under the scope of BS7671
5.
A transportable leisure accommodation vehicle which includes means for mobility but does not meet the requirements for construction and use of road vehicles is a?
6.
20A final circuit is the wiring between?
7.
Which one of the following protective measures is not applicable to equipment in Zone 2 of a swimming pool?
8.
When assessing the frequency and quality of maintenance of an installation, the person responsible for the operation and/or maintenance of the installation shall be:
9.
The effectiveness of protective measures should be considered with regard to:
10.
Heights of sockets and switches from finished floor level in a new domestic dwelling, should be?
11.
Which of the following systems shall not be used to supply equipment used in repair and alteration work on construction sites?
12.
Which part of the building regulations states information about drilling through externals walls, where moisture could cause an issue?
13.
What is the maximum earth fault loop impedance for a 5 sec disconnection time, if the protective device is a 6A type B 60898 MCB and supplied by 55v?
14.
An approximation of the prospective fault current between line conductors, of a 3 phase supply can be determined by?
16.
The symbol used to show that a BS 88 device has a motor circuit application is?
17.
What is the distance, for how far away switches and sockets must be from gas pipework, according to the building regulations?
18.
Triangular yellow safety signs with a black border and symbol are called?
19.
Which specific location would not be included in the scope of BS7671?
20.
Which Classification does this symbol identify?
21.
Circular white signs with a red border and red cross bar are called?
22.
When carrying out an inspection of a new installation, it is not necessary to verify the?
23.
In the new colouring system the neutral in a three-phase AC system will be?
24.
When protecting against burns, a metallic part intended to be touched but not hand held shall be limited to a maximum temperature of?
25.
Circular blue signs with a white symbol are called?
26.
Accessible street furniture enclosures containing live parts shall only be opened using a?
27.
BS 5839 deals with the system design, installation and servicing of?
28.
What earthing system is used in the diagram?
30.
Hi-Viz clothing must ALWAYS be worn when working?
By Neil