Welcome to your 2365 625 Electrical design. This mock exam is not a substitute for proper teaching or revision and should only be used as a resource to prepare learners for the exam. The questions (along with the wording and diagrams) contained within the bank of this exam are purely made up by our lecturers and not copied from any actual qualification exam. So while this is an excellent free revision resource, please do not rely on these exam questions alone to help you be successful within your qualifications. When you are ready, please press "start quiz".
1.
The overall diameter of large CSA multicore armoured cables may be reduced by?
2.
Which of the following is a re-wireable fuse?
3.
The type of wiring for use in a factory with high ambient temperatures is?
4.
Pre-existing damage should be identified then reported and confirmed with the?
5.
If conductors are not clean when making a joint with a crimping tool the most likely results will be?
6.
In cables the abbreviation MIMS refers to ?
7.
If the voltage drop in an installation exceeds the permissible value it may be corrected by?
8.
The minimum bending radii of Mineral Insulated (MICC) cable is how many times the cable diameter for: rework (and non-rework)
9.
The term for a requirement in a Regulation as "absolute" means it?
10.
Which of the following is a cartridge fuse?
11.
Where vertical trunking passes through floors internal fire resistant barriers, must be ?
12.
Which of the following is a re-wireable fuse?
13.
The Health and Safety at Work Act...
14.
The correct title for the conductors that carry the electrical supply in between levels of a building is known as a?
15.
Which one of the following is the minimum conduit size suitable for a short straight run containing the following stranded cables: 8 x 1.5mm² , 2 x 2.5mm² , 2 x 4.0mm²?
16.
Distribution Boards in large factories and commercial premises, should normally be positioned?
17.
Spring toggles are used to fix electrical equipment to?
18.
A circuit breaker offering circuit overload and short circuit protection, operates due to the following effects?
19.
One of the main aims of the Health and Safety at Work Act 1974 is to secure the health safety and welfare of people where?
20.
Where saddles are to be installed to support a long vertical run of conduit to ensure accuracy it would be appropriate to use a?
21.
What voltage is represented by the Blue colour outlets?
22.
What do the letters CDM stand for?
23.
What would cause an RCD to operate?
24.
Cables in wooden joists must be at least what distance from the top or bottom?
25.
A room in which there is a 13A socket outlet is to be converted into a bathroom. The socket outlet must be?
26.
Mineral insulated cables are sometimes provided with an overall covering of pvc to?
27.
What maximum spacing should clips for 2.5mm² T+E, when ran horizontally be at?
28.
What is the maximum percentage of trunking that can be filled with cable?
29.
The correct tool used to cut a 16mm² copper cable to length is?
30.
The disconnection time for ring or radial socket outlet circuits is?
By Neil