Welcome to your Electrical Vehicle Charging exam simulator. This mock exam is not a substitute for proper teaching or revision and should only be used as a resource to prepare learners for the exam. The questions (along with the wording and diagrams) contained within the bank of this exam are purely made up by our lecturers and not copied from any actual qualification exam. So while this is an excellent free revision resource, please do not rely on these exam questions alone to help you be successful within your qualifications. When you are ready, please press "start quiz".
1.
What rating factor would be applied when calculating the current carrying capacity of a cable if it is buried in a duct or the ground?
2.
Every charging point shall be individually protected by an RCD having the characteristics specified in Regulation 415.1.1, which states that the residual current rating of the RCD must be not larger than?
4.
What is a Type 2 Connector also known as?
5.
Further information on using a Vehicle for storage can be found in which Publication?
6.
What is the minimum height of socket outlets that are not required to be accessible?
7.
If a TT is to be provided for an EVSE only (other than on-street), what is the recommended minimum separation distance from other earthing systems?
8.
What information should be handed over to the customer upon completion?
9.
What is the purpose of this label with reference to the IET wiring regulations?
10.
Which one of the following descriptions relating to the extent of an Electrical Installation Certificate would be ticked if charging equipment was installed using a dedicated new circuit?
11.
What is a disadvantage of using mode 3 charging?
12.
Which Mode of charging is in the diagram?
13.
Which of the following describes a V2X service that provides benefits directly to consumers such as providing power during a power cut?
14.
Which one of the following describes Basic Protection?
15.
An EV installation requires an earth electrode to be adopted along with the use of the PME earthing system. What will be the maximum value of RA-ev allowed to limit the touch voltage to 70V, if the demand of Installation including the electric vehicle load is 100A?
16.
What information should be handed over to the customer upon completion?
17.
Which Mode of charging is in the diagram?
18.
Which of the following would you not find in a feeder pillar?
19.
In new principle covered in the BS7671 explains how Installations can generate electricity for their own uses and supply it back to the grid or other installations. does the abbreviation PEI stand for?
20.
Why is Polarity required to be verified?
21.
What type of connector is shown?
22.
During inspection, the presence of the Circuit Protective Conductor must be verified. Which one of the following would satisfy this?
23.
Which symbol does this refer to “the nominal generating output rating of the V2X EVSE”?
24.
Which of the following non statutory documents are available for guidance on Fire safety consideration when installing EVSE?
25.
Charging equipment that is to be installed in an outdoor location shall have an IP rating of at least?
26.
Certain EV installations allow the vehicle to be used as storage. What does the abbreviation V2G stand for?
27.
Which one of the following earthing arrangements is shown in the diagram?
28.
Which of the following is the most appropriate RCD for EV Car Charging Equipment?
29.
Which Charging Connection is in the picture?
30.
Which one of the following may be required from the local Highways, prior to the installation of car charging equipment for On-Street parking?
